Electric Gates UK

Safety Beams & Photocells

Safety beams and photocells are a safety device for use on all gates which are automated.

They are supplied as a pair, and the transmitter emits an infrared beam and the receiver receives the infrared beam.

When the beam between them both is broken, a signal is sent to the control board to stop and/or reverse the gates.

On most installations it is advisable to install a minimum of 2 pairs of photocells.

Safety Edges

Safety edges allow sliding gates and hinge side of swing gates (between pillar and hinge side of gate).

A pressure sensitive safety edge fitted to the leading edge of the gate will prevent the gate from operating when it comes into contact with people and obstructions preventing crushing and injury.

Safety Loop / Induction Loop

A safety loop/induction loop is installed underground just out of the opening sweep of the gate.

This is to protect vehicles; when a vehicle is on top of the loop, the gate will not move.

The vehicle will have to be move from on top of the loop so the gates can operate.

Signage

Installing signs on or next to the gate in clear view of pedestrians is very important to warn them of moving gates and a potential accident zone.

We advise the below signs are used, which we can personalise to include a company logo and telephone number if required.

Please click sign to enlarge